Programmer simplu

The uJDM programmer is built on VeroBoard 22*13 holes in size. The circuit layout shows the top (left) and bottom (right) side of the board. The copper tracks are cut on the bottom side of the board as shown using a PCB cutter or 3.5mm drill bit. Two 3mm holes are drilled through the board for the DBF9F (J1) connector mounting pins.

The DBF9F serial socket is not on a 0.1" spacing as is the VeroBoard so it is necessary to bend and cut off some of the pins on the underside of the connector as shown.

Solder the components starting with the two connectors to make it easier to locate the smaller components. When complete a useful tip is to use Tipex (white correction pen) on the top center of J2 to mark pin one of the PIC socket. If you also do this on the PICs then you are less likely to plug them in upside-down.

Accost programtor foloseste icprog care poate fii descarcat de la adresa http://www.mercaelectronica.com/descargas/archivos_descarga/icprog10